Recent content by Joel Hauser

thanks. my cable is new and not binding. But I think I'm going to fiddle a bit with the TPS just to see what happens. I removed the throttle body this weekend (6/23/2019) and cleaned it out. It was a little gunky because the car had been running rich until I installed the new PCM. Thanks...

I built a factory five roadster aka cobra using the drive train from a 1996 mustang GT. I'm using a 4.6L SOHC engine with 5 speed manual transmission. I am using the stock EFI system. The engine runs great, but sometimes, once it is warmed up, it stalls when coming to a stop. It starts right...

cracked intake manifold

Good Morning, a few months ago I posted that I was looking for a shop in Upstate NY that does custom tuning. Unfortunately no one replied, so I'm posting again with the same question. Can anyone recommend a shop that does custom tuning on a 96-04 4.6 EFI mustang. My car is actually a...

I am new to NYM. I don't actually have a mustang, but built a factory five roadster cobra using a 1996 mustang GT donor car. I did a pretty basic stock rebuild of the engine. I had the cylinder's round bored, the crank journals machined, and the heads serviced. I installed new pistons and...

I just added three pictures to my photo album. Hopefully you can find them easier than I was able to load them.

I built a factory five Mark IV Cobra using a 1996 mustang donor car. I thought I would join this site hoping there would be useful information about engine performance.