Search results

I picked up a nice 65 roller (shell). I am looking for a 65 or 66 parts car with paperwork. Thanks

In the parking lot of the Hospital. This is a big morale booster for the Vets, 2nd Annual. Show your support, see you there.

My GT is giving me some grief. I have a dead short in the fuse circuit controled by fuse 1. I dont have turn signals or backup lights because they run from this fuse. This is what is controlled and what I have checked. (a) air bag module is disconnected (b)Illum. entry disconnected (c) conv. top...

All done except for sand and buff. The stroker engine runs great and kinda scares me. This was a fun build and I hope to get the plates on it next week.

I have a set of PI heads if someone wants them. (free) The good: 2003 heads with only 30000 miles on them. The bad: The car was in a wreck. One head has a broken timing cover lug. The other head has a broken cam bridge mount and bent bolt. The head is not broken. Good parts and cams. I am...

I have the 427 up and running in my 95 GT. Pulled the sprout, set base timing and it runs fine, but idles like crap. Other guys tell me 95's always idle bad after modifications. Where can I go to get a chip burnt? Would a 95 Cobra R ecu help?

Finished the motor and ran it on an engine stand (with a carb). Ran good, sounds good, no strange noises. I put the injection on and just put it in the 95. I am starting to like this project!

Should be done this spring.

I just built a 427 stroker for my 95 GT. I am going to use the T-5 until I can find a reasonable Tremec. The motor is a28 oz. balance. Should I use a 351 flywheel or a 5.0/302 28 oz.?

I just picked up a 95 GT convertible. It has no power top button on the console and the top is manual. Did Ford make a manual top? I never saw one.

Where can I get detailed instructions for swapping a 5.4 DOHC into my 2000 GT.

Hello - new to the site/forum