Search results

My C-4 uses a C-5 case with the fine band adjustment threads. A c-4 will swap right in with some modification to the trans mount and a steeda spacer for the drive shaft. Most aftermarket shifters have a micro switch for the reverse lock-out and neutral safety switch.

Re: Official 1/4 MILE ET Ranking List Thanks dude!

Re: Official 1/4 MILE ET Ranking List Nice run for bolt ons and a tune!! :awesomework:

Re: Official 1/4 MILE ET Ranking List No point in wasting time uploading the slip because I haven't sprayed the car yet but here is the best N/A run. 60' - 1.456 330'- 4.206 1/8 - 6.509 MPH - 106.58 1000' - 8.512 1/4 - 10.202 MPH - 132.95 Not too bad for an 302 based 359 cube motor. Should go...

Haha! That smiley is awesome!!

From what I understand FFW is done.

Well then, I stand corrected! :nono: HaHa

Welcome to NYM!

Cool! I see you are a Jeg Coughlin fan as well! :awesomework:

That's flyin. Hoping to get my 84 fox in the 8's this year in the 1/4. If you have any vids of your runs you should post them. Everyone here eats that shit up when the members post vids of their cars! Again, welcome!!

South Georgia is an awesome track! What does the dragster run?

Welcome to NYM!

Call Matt at Pro-Formance Specialties. The website is in my signature. I won't bring my engines anywhere else. Even if you think he might be too expensive at least give him a call. Tell him the Vanstrom brothers sent you.

Welcome welcome!!!

Welcome to NYM! Where are you from in GA? I was stationed in Valdosta for a while. Kinda liked it there.

Yep, put it back!

HaHaHa!!!

Welcome to NYM!

Looked like fun! I've never been to Esta. How far is it from Buffalo?

Hey BMad. Matt Schaff at Pro-Formance Specialties in Rochester did the machine wok and assembly. He does have an engine dyno.