Search results

Just wanna see if anyone is interested in a set of high and low beam HID kit complete with all hardware. I put this on my Mach 1 and I am looking to go in a different direction. these are a a 6000k white set

I was driving the mach saturday and at one point I was in third gear at part throttle and the car started to buck and surge. I thought it was me so I ignored it. Then i was coming home from ossning getting onto the parkway, I stepped on it in fourth and it coughed once and then it was fine...

Does anyone know of a reputable person to roll the lips on my rear fenders? I picked up a set of 10x28.5 slicks on 15" prostars and I don't want to take a chance cutting a tire.

There's a car show this friday at Hopewell Auto Parts. I'll be there with a few buds, BRING THE STANGS!!!! Starts at 6 pm and goes till 10 I think.:awesomework:

This is a run from about a year ago. 427hp.and 478 tq.d8hdZoCpOFk#

I just got the call from the machinist and my engine is almost complete! This has been a slow process because I've been sending him money here and there. The parts list is as follows. Teksid block .020 over, line bored and decked. Kellogg crank, Manley H-beams, Wiseco forged 10.7:1 compression...

Just heard thru the grapevine thers a car show 5-16 at the Arlington High School. Pre register, pay $5 register day of $15 Reg starts @ 9 am. Email Dan at dflanagan@acsdny.org I'll be there, hope to see all of you. I look forward to meeting all of the Mustang nuts!:D

I'm trying to figure out what bulbs my mach's Instrument cluster uses, There not 194's and there a little bigger than 74's. Any ideas??

Heres my dyno run at Mustang Majic, made 430 hp and 480 tq. Kind of a low number cause my fuel pump pegged at over 90% duty cycle. I tried to play it safe until the new engine is completed. I added a ford GT fuel pump shortly after that, so I could pill it up to a 150 shot, but traction becomes...

I have a super clean MAC prochamber with under 20k miles, comes with O2 sensors, asking 125.00