8/8/16 Cut out the rear section of the l/s inner cowl panel that was starting to rust through where it is welded to the door post.
8/8/16 Cut out a small piece from the lower rear section of the l/s door post that had some pin holes in it.
8/7/16 Tested the fit of the Monte Carlo bar.
8/6/16 Bolted the drivers side seat back in.
8/6/16 I welded in the seat platform
8/5/16 I finished welding in the l/s long floor & started fitting the seat platform.
8/3/16 I started welding in the l/s long floor until I ran out of welding wire.
Mike65

8/6/16 Bolted the drivers side seat back in.

Media information

Album
69 Mustang Coupe.
Added by
Mike65
Date added
View count
313
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media